BT RRE140 - Replacing Bearings; Replacing the Rollers

Mast/Lift system 7000
Fork spread unit
Publication No. Date Valid from serial number T-code
261828-040 2008-08-21 6051502 815, 816
© BT Repair Manual RRE140/160/180/200/250 15 – 31
Replacing bearings
1. Remove the outer lock ring (d) and wiper seal (c).
2. Remove the inner lock ring (b) and wiper seal.
3. Remove the bearing (a).
4. Fit the new bearing and refit the outer and inner lock rings and wip-
er seal.
5. Apply locking fluid to the screws (e) on fitting.
Replacing the rollers
1. Remove the tension pin (g) from the fork lug.
2. Push the axle (f) out.
3. Remove the roller (h).
4. Place a new roller in position.
5. Push the axle in.
6. Fit the tension pin.
d
e
h
f
g
c
b
a