BT RRE140 - Assembling the Drive Motor

Motors 1000
Drive motor (1760)
Publication No. Date Valid from serial number T-code
261828-040 2008-08-21 6051502 815, 816
© BT Repair Manual RRE140/160/180/200/250 9 – 17
9.5.5 Assembling the drive motor
Ensure all parts are intact and clean before assembly.
1. Using standard tools, insert a new ball bearing (m) in the N-shield.
2. Place the locking ring (n).
3. Position the D-shield (a) against the stator in line with the markings
(b).
IMPORTANT!
If the original parts are being used, the stator (b) and the D-shield
(drive end) (a) should have their relative mounting positions clearly
marked, as in the illustration.
4. Insert the rotor shaft in the bearing and place the locking rings (e)
on the rotor shaft.
5. Insert the rotor (k) with the N-shield in the stator.
m
n
e
k