Hydraulic system 6000
Hydraulic system, mast (6300)
Publication No. Date Valid from serial number T-code
261828-040 2008-08-21 6051502 815, 816
© BT Repair Manual RRE140/160/180/200/250 14 – 17
14.4.3 Checks after fitting
When the hose reel is used for the first time, lift the forks carefully to the
maximum lift height. Check that the hose and hose drum work correctly
and count the number of turns that the hose drum rotates.
The total for the number of turns made by hand when preloading plus
the number of turns for maximum extraction must not exceed 10.
Turns on preloading + turns in operation = 10 turns max.
IMPORTANT!
At maximum lift height, the hose must not be fully unwound from the
hose drum. At least
¼ of a turn of hose must still remain on the hose
drum.
Make sure that the hose drum can still be turned by hand with the hose
fully extracted. The hose drum must not lock.
Check that the hose rewinds correctly when the forks are lowered. The
hose must always be under tension, otherwise there is a risk of the
hose sliding over the side plates. If this is the case, adjust the preload
-
ing tension.
IMPORTANT!
The spring-loaded eye must face the direction in which the hose un-
winds.
Spare parts must conform to the technical specifications laid down by
the manufacturer. This requirement is always met if original spare parts
are used.
To Next Page
Loading...
