15 – 22 Repair Manual RRE140/160/180/200/250 © BT
Mast/Lift system 7000
Reach carriage (7190)
T-code Valid from serial number Date Publication No.
815, 816 6051502 2008-08-21 261828-040
15.3 Reach carriage (7190)
15.3.1 Adjusting radial play in the reach
carriage
1. Run out the reach carriage and the battery.
2. Lift the battery off, but put it in a position so that it can be connected
up, alternatively so that power can be supplied to the truck from a
different external source.
3. Place a load on the forks. The weight of the load must be great
enough for both the right and left rear roller to sit flush against the
top beam flanges.
4. Place the eccentric rollers (a) against the bottom flange and tighten
the lock nut (c) (36
mm hexagonal nut) until the axles (b) can rotate
(32
mm hexagonal fitting), but provide some resistance.
(Once the nut has been placed against the washer, tighten the nut
(c) by approximately 0.5–1 turn.)
5. Check that the eccentric rollers are up against the beam (arrow)
once the nut has been tightened.
6. Slowly run the reach movement fully in and out again; do this care-
fully so that the load holds the rear runners against the top beam
flanges for the entire time.
a
b
c
To Next Page
Loading...
