Functions and parameters
Parameters
Publication No. Date Valid from serial number T-code
261828-040 2008-08-21 6051502 815, 816
© BT Repair Manual RRE140/160/180/200/250 4 – 77
Calibration parameters, overview
No.
Min. Max.
Incre
ment
Defaul
t
Unit
Description
Hydraulic parameters
1252 –200 200 5 0 mA Free lift calibration
1253 –200 200 5 0 mA Free lowering calibration
1254 –200 200 5 0 mA Lift calibration for main mast
1255 –200 200 5 0 mA Lowering calibration for main mast
1256 –200 200 5 0 mA Calibration of reach out
1257 –200 200 5 0 mA Calibration of reach in
1258 0 30 1 10 % Extra flow for reach mast valve. Extra flow in
% used for reach mast valve. In this way the
reach mast function is controlled by the
pump and not limited by the valve.
1259 –200 200 5 0 mA Ergo cabin, tilt up calibration
1260 –200 200 5 0 mA Ergo cabin, tilt down calibration
1261 15 40 1 30 % Flow on upward transition. Specifies the flow
in % when the free lift valve should close
during lift transition from free lift to main lift.
For smooth transition between the two mast
sections.
1262 15 40 1 30 % Flow during downward transition. Specifies
the flow in % when the main lowering valve
should close during lowering transition from
main lift to free lift. For smooth transition
between the two mast sections.
1263 0 1000 10 240 kg Weight of the fork carriage in kg, for calcula-
tion of the load on the forks.
1264 0 2000 10 990 kg Weight of the mast + fork carriage in kg, for
calculation of the load on the forks.
1265 120 840 12 564 mm Reach length. The total length of the reach
movement (in mm) so that the movement
can be dampened in the end positions.
1266 –300 300 5 0 kg Weight 1 calibration
1267 500 3000 5 1000 kg Reference weight 2
1268 –300 300 5 0 kg Weight 2 calibration
1269 –200 200 5 0 mA Calibration of free lift lowering speed.
1270 –200 200 5 0 mA Calibration of main lift lowering speed.
1271 0 9000 2 800 mm Free lift, height reference
1272 0 100 2 30 mm Main lift, height reference
1273 0 6000 2 3000 mm Free lift height