15 – 24 Repair Manual RRE140/160/180/200/250 © BT
Mast/Lift system 7000
Reach carriage (7190)
T-code Valid from serial number Date Publication No.
815, 816 6051502 2008-08-21 261828-040
15.3.2 Adjusting axial play in the reach
carriage
When adjusting lateral play in the reach carriage, it is important that:
• the wheel on each side is adjusted by the same amount
• the reach carriage is centred in the chassis
• the carriage runs straight and smoothly without jamming or coming
loose.
1. Fully run out the reach carriage.
2. At each roller, measure the play between the reach carriage and
support arms.
3. Remove the locking screw (a) (16 mm allen screw) from the adjust-
er of each roller.
4. Adjust the rollers (10 mm allen screw) so that the reach carriage is
parallel with the support arms and centred between the support
arms.
5. Once the reach carriage has been correctly adjusted, place the ad-
justing rollers against the support arm and turn the adjusting
screws back one ¼ turn.
6. Lock the adjusting screws.
7. Test run the reach carriage out and in, making sure the carriage
runs smoothly without jamming.
8. Check that the rollers come up against the reach stop at the same
time as the carriage is run fully out.
9. If necessary, adjust the stop on the side the roller strikes first by
sanding it down until both rollers strike the stop simultaneously.
To Next Page
Loading...
