BT RRE140 - Replacing the Drive Gear

10 – 2 Repair Manual RRE140/160/180/200/250 © BT
Drive gear 2000
General
T-code Valid from serial number Date Publication No.
815, 816 6051502 2008-08-21 261828-040
10.1.2 Replacing the drive gear
Special tools
Lifting eye for motor
3 screws, M12x110 mm
Exposing the drive gear
1. Prepare the truck for servicing.
2. Remove the fender (a) and the step plate (b).
3. Remove the fixing screw (arrow) for the floor and pedals.
4. Undo the connector units for the pedal harness (press the lugs of
the female contact together to undo the contact).
5. Remove the floor and pedals.
L
Removing a drive motor from the truck
See the section "Removing the drive motor from the truck".
Removing a steering motor from the truck
See the section "Removing the steering motor from the truck".
a