12 – 6 Repair Manual RRE140/160/180/200/250 © BT
Steering system 4000
Steering reference sensor (4350)
T-code Valid from serial number Date Publication No.
815, 816 6051502 2008-08-21 261828-040
12.2 Steering reference sensor (4350)
General
These instructions apply for replacement of the steering reference sen-
sor located on the drive gear housing, up against the drive motor.
When replacement of the sensor is due, first remove the floor, as
described in the section "Replacing the drive gear".
12.2.1 Replacing the reference sensor
The sensor does not need adjusting on replacement.
1. Remove the screw holding the old sensor (5 mm allen screw).
2. Undo the connector unit for the sensor.
3. Place the new sensor and screw it tight.
4. Connect the harness.
5. Refit the floor.
a
To Next Page
Loading...
