15 – 34 Repair Manual RRE140/160/180/200/250 © BT
Mast/Lift system 7000
Manual telescopic forks
T-code Valid from serial number Date Publication No.
815, 816 6051502 2008-08-21 261828-040
15.8 Manual telescopic forks
15.8.1 Fitting
DANGER!
Risk of injury. Fingers, other body parts or objects may not be insert-
ed in the holes on the fork blade or extended section. These holes are
only intended for locking with locking bolts.
1. Push the bolt (a) upwards until it reaches the stop.
2. Turn the bolt anticlockwise until it is held by the stop.
3. Remove the bolt.
4. Push/pull the extended section (b) to the required position. Use the
handle under the tip on the extended section.
5. The hole in the extended section must be in line with a hole in the
original fork, so that the extended section can be attached to the
original fork.
6. Avoid using too much force to position the extended section, as this
can damage the stop screw (c).
7. Place the bolt in the hole. Check that the grooves in the bolt corre-
spond to the original fork.
8. Turn the bolt clockwise until it is held by the stop.
IMPORTANT!
The locking bolts must not stick up above the surface of the fork. The
bolt must be correctly inserted. The fork must not be used until the
bolt has been correctly secured.
Avoid using too much force to pull the extended section towards the
end stop, as this can damage the stop screw.
The stop screw (c) must be screwed into the extended section and se-
cured using Loctite 242, for example. It may only be removed to allow
replacement of the extended section. It must then be screwed back in
and secured.
a
b
c
To Next Page
Loading...
