14 – 22 Repair Manual RRE140/160/180/200/250 © BT
Hydraulic system 6000
Reach cylinder (6650)
T-code Valid from serial number Date Publication No.
815, 816 6051502 2008-08-21 261828-040
14.7 Reach cylinder (6650)
14.7.1 General
The reach cylinder is located in the reach carriage.
The reach cylinder is a double-acting cylinder.
The direction of the cylinder is governed by the main valve.
14.7.2 Removing the reach cylinder from the
truck
1. Fully extend the mast.
2. Remove the battery cut out connector from the truck.
3. Remove the reach carriage graduated rule. This is attached at
each end by snap fasteners and can be lifted out by gently tugging
on it.
4. Remove the hoses from the reach cylinder and plug them.
5. Remove the locking rings from the cylinder pins.
6. Remove the reach cylinder.
14.7.3 Placing the reach cylinder in the truck
1. Fit the reach cylinder to the pins.
2. Put the locking rings in position on the pins.
3. Fit the hoses to the cylinder.
4. Fit the reach carriage graduated rule. This has a snap fastener at
each end and is attached by gently pressing on it.
To Next Page
Loading...
