BT RRE140 - Replacing the Wiring Harness in the Operating Console

Steering system 4000
Electric steering wheel (4310)
Publication No. Date Valid from serial number T-code
261828-040 2008-08-21 6051502 815, 816
© BT Repair Manual RRE140/160/180/200/250 12 – 3
12.1.4 Replacing the wiring harness in the
operating console
1. Remove four screws (a) (torx 10) from the underside of the steering
wheel module.
2. Remove the bottom panel (b).
3. Remove two screws (c) (torx 10) together with the pulse transduc-
er.
4. Remove the top panel (d).
5. Undo the connector unit (e) by the transducer.
6. Remove the screws (torx 25) and sleeve (g) by the steering wheel
module joint.
7. Unscrew the adjusting screw (f) all the way so that the steering
wheel module is free of the operating console.
a
b
c
d
f
g
e