14 – 16 Repair Manual RRE140/160/180/200/250 © BT
Hydraulic system 6000
Hydraulic system, mast (6300)
T-code Valid from serial number Date Publication No.
815, 816 6051502 2008-08-21 261828-040
14.4 Hydraulic system, mast (6300)
14.4.1 Mast-mounted hose reel (6370)
General
These assembly instructions contain the information needed for trou-
ble-free installation and operation. The enclosed operating instructions
contain information relating to inspection and maintenance, as well as
the instructions.
14.4.2 Fitting the hose reel
To preload the spring, the hose drum should be rotated in the direction
of hose extraction, with the hose fully wound.
Preloading the hose drum:
• For extraction to the right, rotate the drum clockwise.
• For extraction to the left, rotate the drum anticlockwise.
DANGER!
Loaded spring.
The hose can cause injury.
Always exercise caution when working with the hose reel.
The number of turns depends on the length and diameter of the hose -
see the table. The stated values apply as guideline values.
Spring preloading (turns)
The hose is only pulled out from the drum once the correct preloading
value has been reached.
Hose diameter
(mm)
Hose length (m)
2.7 3 3.3 5 6 7 8.5
6.3 - - 4 3 3 3 1.5-2
8 4 4 - 3 3 - -
To Next Page
Loading...
