Mast/Lift system 7000
Reach carriage (7190)
Publication No. Date Valid from serial number T-code
261828-040 2008-08-21 6051502 815, 816
© BT Repair Manual RRE140/160/180/200/250 15 – 23
7. Once the reach carriage is back in its original position, use a feeler
gauge to check play between the eccentric rollers and the beam
flange (arrow).
It should be easy to insert the feeler gauge without using force. A
suitable interval on the feeler gauge is 0.1 mm.
8. Select a feeler gauge that is 0.1 mm thicker (or a minimum of 0.3
mm) than the one that can be inserted between the roller and
flange.
9. Turn the eccentric axle (b) to increase play with the flange, insert
the feeler gauge you have selected, and turn the axle back so that
there is slight pressure from the eccentric roller against the feeler
gauge.
10. Tighten the lock nut (36 mm hexagonal nut) to 220 Nm. Make sure
you brace the axle so that it does not rotate as the nut is tightened.
11. Withdraw the feeler gauge. (If the feeler gauge has got stuck, give
the tool in the eccentric axle a slight tap in the opposite direction so
that the feeler gauge comes loose).
12. Reset the truck for normal operation.
a
b
c
To Next Page
Loading...
