14 – 6 Repair Manual RRE140/160/180/200/250 © BT
Hydraulic system 6000
Hydraulic unit (6100)
T-code Valid from serial number Date Publication No.
815, 816 6051502 2008-08-21 261828-040
14.1.5 Fitting the pump motor in the truck
1. Screw a lifting eye into the end of the motor shaft and connect it to
a traverse if necessary.
2. Lift the hydraulic pump into the truck and at the same time run the
hydraulic hose (c) from the tank to the pump.
3. Tighten the hose clamp.
4. Tighten the screws (a) (6 mm allen screws) that hold the pump mo-
tor mounting.
5. Unscrew the lifting eye.
6. Replace the hydraulic hose (b) in the quick change connector.
7. Connect the temperature and speed gauge contacts and the power
cables.
8. Check the oil level and if necessary top up the hydraulic oil in the
tank.
9. Before any hydraulic function is initiated:
Put the truck program in service mode and activate the service po-
sition for bleeding.
a
b
c
To Next Page
Loading...
