WEB UP function
MATRIX CUBE - 38 -
EXIT to return to configuration menu.
Single Device Numbering (DIAPER FEEDER)
To number a single DIAPER FEEDER device (for instance in case of replacement) operate as follows:
• Carry out all the operations described on Device
Configuration and Numbering paragraph, until the
screen showing the Current TS55 and total device
numbers appears on the terminal display.
• To move immediately to the DIAPER FEEDER
numbering procedure.
• Select the DF IDENTIFY option to open the DIAPER
FEEDER identification screen.
• Select on the CURRENT field, the number of device to
be re-numbered (e.g. 002).
• Press Enter on DIAPER FEEDER device number 002
and check that:
a) The red LED of TS44 tension sensor turns off and
the LEDs of Control, Enter and Reset buttons
remain steady green.
b) The display of numbered device shows the
assigned number (e.g. 002).
To leave the identification procedure once you have re-
numbered the desired device.
EXIT to return to configuration menu.
To Next Page
Loading...
