Buffalo LS421DE - Changing the IP Address

77
Changing the IP Address
Normally, the LinkStation’s IP address is set automatically from a DHCP server on your network. If you prefer, you can set
it manually. An easy wayto do this is to change it from NAS Navigator2 running on a computer connected to the same
router (subnet) as the LinkStation.
Note: You can also change the LinkStation’s IP address from Network - IP Address in Advanced Settings.
1 Double-click the icon on the desktop. NAS Navigator2 will start.
2 Right-click on your LinkStation’s icon, then choose Properties - IP Address. On the Mac, click the LinkStation’s icon
while holding down the control key, then click Configure - IP Address.
3 Enter the IP address and subnet mask, then click OK.