78
Chapter 9 Utilities
NAS Navigator2 for Windows
NAS Navigator2 is a utility program that makes it easy to display Settings, change the LinkStation’s IP address, or check
its hard drive. If you installed the LinkStation with the LinkNavigator CD, NAS Navigator2 was installed automatically.
NAS Navigator2 will run in the system tray when the computer is on.
To launch NAS Navigator2, double-click the icon.
Click your LinkStation’s icon to open a share on the LinkStation and display:
• Total capacity
• Capacity in use
• IP address
• Workgroup
• Subnet mask
• Default gateway
• MAC address
• Firmware version
To Next Page
Loading...
