Buffalo LS421DE - Configuring a Backup Job

51
4 Select the IP address of the LinkStation or TeraStation that you want to set as the backup target. Click Add, enter
the IP address of the target LinkStation or TeraStation, and click Close.
If your setup meets the requirements below, you don’t have to configure these settings.
• The source and target LinkStations are on the same network.
• No backup password is set for the target LinkStation.
• No LinkStation from outside the subnet, or connected by a VPN, is used.
Notes:
• To back up data between LinkStations or TeraStations on a network using jumbo frames, make sure that both de-
vices are configured to use identical (or similar) Ethernet frame sizes. If Ethernet frame sizes are significantly dif-
ferent, the backup job may not be properly performed. In such a case, select the default frame size (1518 bytes).
• You can also specify hostname by a fully qualified domain name (FQDN).
Configuring a Backup Job
1 In Advanced Settings, click Backup.
2 Click to the right of “Backup”.