Buffalo LS421DE - Page 84

84
E22 Mounting of hard drive X failed.
Format the hard drive. After formatting,
if the error still appears after rebooting,
replace the hard drive. If the error is
displayed again, contact Buffalo technical
support for assistance.
E23
An error occurred, so the hard drive was
removed from the RAID array.
Replace the hard drive whose NAS
Navigator2 or Settings shows error.
E30 An hard drive error occurred.
Replace the hard drive whose NAS
Navigator2 or Settings shows error.
Amber
If there is a status message, the power LED will blink amber. The pattern of the blink gives the information code. You can
also see any status messages in NAS Navigator2.
Place Status
10s Place
The LED flashes for 1.0 seconds every 0.3 seconds. This gives the tens place of
the information code.
1s Place
The LED flashes for 0.5 seconds every 0.3 seconds. This gives the one place of
the information code.
Information Code Description Corrective Action
I10
A rise in system temperature may have
exceeded the allowable safety value.
Move the LinkStation to a cool location.
Do not place objects in the area around
the LinkStation.
I11
The bad sectors in hard drive X may have
reached a dangerous level.
Replace the hard drive X.
I12 Operating in degraded mode. -
I13 Formatting RAID array X. -
I14 Checking RAID array X. -
I15
Examining the error status of RAID array X.
Note: Transfer speeds are slower during
the examination process.
-
I16 Creating RAID array X. -
I17
Resynchronizing RAID array X.
Note: Transfer speeds are slower during
resynchronization.
-
I18
Rebuilding RAID array X.
Note: Transfer speeds are slower during
the rebuilding process.
-
I19 Writing 0s to RAID array X, erasing all data. -
I20 Formatting hard drive X. -
I21 Checking hard drive X. -
I22 Erasing the data for hard drive X. -
I23 System is being initialized. -
I25
Updating the LinkStation firmware.
Note: Do not turn off the power during
the updating process.
-
I26 Initializing all settings. -
I27 Checking USB hard drive. -