SECTION 3 - LUBRICATION AND MAINTENANCE
3-24
EVERY 10 HOURS OR DAILY
OPERATION 12
Brake Adjustment
The foot and park brake unit is self-adjusting and
requires no maintenance.
Engaging and disengaging the park brake lever,
1, several times will activate the self-adjusting
mechanism within the caliper and keep the brake
in proper adjustment. This will ensure a proper
set point for the brake to stop the tractor and hold
it on an incline when parked.
Figure 3-25
1
Visually inspect the brake rotor, 1, for nicks or
damage and the brake pads for wear. The pads
must be replaced if they are worn to 1 mm (1/32″)
or less. Consult your Buhler Versatile dealer for
assistance in replacement of the brake rotor or
pads.
WARNING: DO NOT OPERATE THE
TRACTOR WITHOUT THE BRAKES IN GOOD
WORKING ORDER.
Figure 3-26
1
OPERATION 13
Lubricate the Optional 3-Point Hitch
The 3-point hitch linkage requires lubrication to
maximize performance.
Lubricate the grease fittings, 1, located at the top
pivot pin point of each lift cylinder.
Figure 3-27
1
To Next Page
Loading...