SECTION 3 - LUBRICATION AND MAINTENANCE
3-67
AS REQUIRED
OPERATION 62
Headlight/Work Lights Bulb Replacement
The sealed beam headlights and work lights can
have the bulbs replaced in them by the following
procedure:
Pivot the light to expose the two screws, 1, on the
back of the molded plastic cover. Remove the
two screws.
Figure 3-107
1
Unplug the wire connectors from the bulb and
discard it. Reattach the wire connectors to the
new bulb and place it into the cover. Reinstall the
screws.
Replacement bulbs can be purchased from your
Buhler Versatile dealer.
Figure 3-108
To Next Page
Loading...