SECTION 1 - GENERAL INFORMATION
1-33
The rear shield, 1, in the back of the cab can
be removed by loosening the two wing nuts, 2,
and pulling the shield away from the rear wall
of the cab. Once the shield is removed, the
umbilical cord can be routed to the monitor
box.
Figure 1-50
2
1
2
7. Antennas for CB radios and cellular phones
can be installed in the roof cap, 1. These items
should be of such quality that they are
shielded to prevent interference with tractor
controls and instruments. Consult the radio or
phone manufacturer for proper antenna
installation.
The roof cap has additional antenna mounts
under the right-hand and left-hand rear corner
of the roof panel. These mounts can be used
by the operator for additional electrical
devices that require an antenna be mounted
on the tractor.
The roof cap also has two flat mounting
locations on top for mounting rotary style
beacons.
Figure 1-51
1
To Next Page
Loading...
