6
Basic Safety Instructions
To prevent injury, ensure that:
The system cannot be activated unintentionally.•
Installation and repair work may be carried out by authorised •
technicians only and with the appropriate tools. Use original
spare parts only.
After an interruption in the power supply or pneumatic supply, •
ensure that the process is restarted in a defined or controlled
manner.
The actuators and accessory parts were developed having
regard to recognized safety engineering regulations and
represent the state of the art.
However, risks may arise. Only operate the device in impec-
cable condition and while observing the operating instruc-
tions.
Pay attention to the working instructions, their sequence and
to safety information and safety labelling when installing the
respective components.
Failure to observe this information and incorrect access of
the device releases us from all liability and annuls the guar-
antees applicable to the devices and accessories.
The actuators contain pre-tensioned springs that may derail or slip
on improper opening.
Actuators K-175 and L-225 shall only be opened in our factory •
or by the responsible distributor..
Only tools specifically provided by Bürkert for the purpose must be •
used to screw down the actuator cover.(see chapter on assembly
accessories).
english
To Next Page
Loading...
Need help?
General
