Burkert 8032 User Manual

16
Technical data
6.3. Technical data of the SE32 with
S077 sensor-fitting
6.3.1. Conditions of use
→ See conditions of use of the SE32, chap. 6.1.1, page 11.
6.3.2. Compliance to standards and
directives
The applied standards, which verify conformity with the EU Direc-
tives, can be found on the EU Type Examination Certificate and/or
the EU Declaration of Conformity (if applicable).
Conformity to the Pressure Equipment Directive
→ Make sure the device materials are compatible with the fluid.
→ Make sure the pipe DN is adapted for the device.
The device conforms to Article 4, Paragraph 1 of the Pressure
Equipment Directive 2014/68/EU under the following conditions:
• Device used on a pipe (PS = maximum admissible pressure;
DN = nominal diameter of the pipe)
Type of fluid Conditions
Fluid group 1, Article 4, Paragraph 1.c.i DN≤25
Fluid group 2, Article 4, Paragraph 1.c.i
DN≤32
or PSxDN≤1000
Type of fluid Conditions
Fluid group 1, Article 4, Paragraph 1.c.ii
DN≤25
or PSxDN≤2000
Fluid group 2, Article 4, Paragraph 1.c.ii
DN≤200
or PS≤10
or PSxDN≤5000
6.3.3. Dimensions
→ Please refer to the technical data sheets regarding the
type SE32 associated with S077 sensor-fitting, available at:
www.burkert.com
6.3.4. Material data
Part
in contact with the medium
Material
• Sensor-fitting
• Refer to the Operating Instructions
of the related sensor-fitting (S077)
→ Also see the material data of the type SE32, chap. 6.1.4,
page 12.
6.3.5. Electrical data
→ See electrical data of the SE32, chap. 6.1.5, page 12.
English
Type 8032 - SE32

Burkert 8032 Specifications

General

Brand	Burkert
Model	8032
Category	Measuring Instruments
Language	English