Burkert 8694 - Essential Safety Precautions

10
Basic safety instructions
3 BASIC SAFETY INSTRUCTIONS
These safety instructions do not consider any contingencies or incidents which occur during installation,
operation and maintenance.
Theoperatorisresponsibleforobservingthelocation-specicsafetyregulations,alsowithreferencetothe
personnel.
DANGER
Riskofinjuryfromhighpressureanddischargeofmedium.
▶ Beforeworkingonthedeviceorsystem,switchothepressure.Ventordrainlines.
DANGER
Riskofinjuryfromelectricshock.
▶ Beforeworkingonthedeviceorsystem,switchothepowersupply.Secureagainstreactivation.
▶ Observe applicable accident prevention and safety regulations for electrical equipment.
Topreventinjury,ensurethefollowing:
▶ Secure device or system to prevent unintentional activation.
▶ Only trained technicians may perform installation and maintenance work.
▶ Perform installation and maintenance with suitable tools only.
▶ Do not make any changes to the device and do not subject it to mechanical stress.
▶ Operate the device only in perfect state and in consideration of the operating instructions.
▶ Observe the general rules of technology.
▶ Install the device according to the regulations applicable in the respective country.
▶ Donotfeedcorrosiveorammablemediaintothedeviceconnections.
▶ Donotfeedanyuidsintotheconnectionsofthedevice.
▶ After the process is interrupted, restart in a controlled manner. Observe sequence:
1. Connect electrical or pneumatic power supply.
2. Charge the device with medium.
▶ Observe intended use.
ATTENTION!
Electrostaticsensitivecomponentsormodules.
The device contains electronic components, which react sensitively to electrostatic discharge (ESD).
Contact with electrostatically charged persons or objects is hazardous to these components. In the worst
case scenario, they will be destroyed immediately or will fail after start-up.
▶ Observe the requirements in accordance with EN 61340-5-1 and to minimize or avoid the possibility of
damage caused by sudden electrostatic discharge.
▶ Also ensure that you do not touch electronic components when the power supply is on.
english
Type 8694 REV.2