burmeier Lenus - Location requirements; Assembling the mattress base frame

Instruction Manual for Lenus Care Bed
Page 18
3.3 LOCATION REQUIREMENTS
Note the following safety relevant aspects to take into account when selecting the site of use:
• There must be sufficient room available to accommodate the bed’s entire range of
adjustments. There must be no furniture, windowsills, sloping roofs etc. in the
adjustment path of the bed.
• The space underneath the bed must remain free.
• Before using the bed on parquet flooring, check whether the castors will leave stains
on the parquet varnish. The bed can be used on tiles, carpet, linoleum or laminate
flooring without causing any damage. BURMEIER is not liable for any floor damage
that may be caused by day-to-day operation.
• A properly installed 230 volt mains socket must be available close to the bed (if
possible) and available at any time.
• Position the bed so as to allow easy access to the power plug at all times so that the
bed can be disconnected from the mains, if necessary.
• If any other additional equipment is attached to the bed, (e.g. compressors for
positioning systems etc.), ensure that this is securely fastened and functions
properly. Pay special attention here to the safe routing of all loose connector cables,
tubing etc. If you have any queries or concerns, consult the manufacturer of the
additional equipment or BURMEIER.
Damage to flooring
Damage to the flooring during assembly and dismantling of the bed may be
caused by the sharp edges of the chassis or the mattress base.
• Carefully assemble or dismantle the bed on protective covers to prevent
damage to the flooring.
3.4 ASSEMBLING THE MATTRESS BASE FRAME
Proceed as follows to install the mattress base frame:
Remove the safety side bars and the patient lifting pole from the storage aid and
set them aside for the time being.
Remove the two halves of the mattress base frame from the storage aid.
Carefully place the head-end half and the foot-end half of the mattress base
frame onto the floor. The four mattress retainer bars should face upwards, while
the two drives face downwards.
Then fit the two halves of the mattress base frame together.
Set the long side of the mattress base frame on the floor and rest the frame
against the wall.
Remove the four long screws from the storage aid and use them to fix the two
halves of the mattress base frame together (in the middle).
Now carefully lay the assembled mattress base frame flat on the floor.