burmeier Lenus - Removing;installing the safety sides

Instruction Manual for Lenus Care Bed
Page 57
4.7 REMOVING/INSTALLING THE SAFETY SIDES
The removal/installation of the safety sides is necessary if the integrated bed extension
(optional equipment) is to be pulled out.
To avoid any injuries, removal/installation work may be carried out only when
the bed is unoccupied.
4.7.1 Removal
Similar to illustration!
1.
Raise the bars.
2.
Press the orange release
button 1 in the safety side
guide at the foot end
downwards with your finger
and lift out the top bar.
3.
Repeat step 2 at the other end
of the bar.
4.
Repeat steps 2
and 3 for the bottom bar.
4.7.2 Installation
See chapter 3.7.
1