To ensure all bed components are securely fixed, all the screws of the bed
must be tightened using the supplied assembly key. Tightening the screws by
hand is not sufficient and can lead to bed components loosening during
operation.
• Tighten all the screws of the bed using the supplied assembly key.
3.2 INCLUDED IN THE PACKAGE
The bed is delivered unassembled, with the parts mounted on a storage aid. Assembly
is carried out on site by the operator’s technical staff. The assembly work can be carried
out by one or two persons.
• Remove all packaging materials and cable ties before starting to assemble the bed.
Observe the disposal instructions in chapter 10.
Note: In order to prevent any damage to the bed chassis parts during transport and
assembly, the head section chassis and the foot section chassis are each secured with
a plastic screw (see 1).
Attention! These screws must remain in place until the chassis have been mounted on
the mattress base frame (see chapter 3.5). It is essential that these screws be removed
before any electrical adjustments to the bed are made!
To Next Page
Loading...
