Instruction Manual for Lenus Care Bed
Page 94
10 Dismantling the bed
• Move the backrest, thigh rest and lower leg rest to a horizontal position.
• Move the mattress base to the highest position.
• Disconnect the power plug/power adapter plug from the mains socket.
• Remove the patient lifting pole.
• Remove the safety side bars, see chapter .
• Remove the side panels.
• Disconnect the plug from the thigh rest motor.
• Take the connecting cables of the lift and thigh rest motors out of their guides.
• Remove the 4 middle connecting screws of the mattress base.
• Remove the screws that connect the mattress base to the head section chassis and
foot section chassis.
Risk of injury
Failure to observe this instruction can result in injuries and damage to
property due to bed components falling down or falling over.
• From now on, do not move the bed from where it is standing, since the
components are no longer screwed together.
• Plug the power adapter plug back into the mains socket.
• Move the bed to the lowest position.
• Disconnect the power adapter plug from the mains socket.
• Disconnect the plugs from the lift motors.
• Pull the head section chassis and foot section chassis out of the mattress base.
Caution:Do not let the mattress base fall to the ground.
• Separate the two halves of the mattress base by pulling them apart.
If the bed is to be placed on a storage aid:
• Connect the two chassis to the transport and storage aid. To do this, use the four
connecting screws of the mattress base frame.
• Place the two halves of the mattress base into the transport and storage aid.
• Place the patient lifting pole and the safety side bars into the storage aid.
To Next Page
Loading...
