Instruction Manual for Lenus Care Bed
Page 76
6.5.2 Replacing the handset
• If possible, raise the mattress base to the maximum height, for ease of access.
• Unplug the power adapter from the mains socket.
• Track the handset cable to the connecting point on the MJB2 junction box:
• Using a flat-blade screwdriver, carefully pull the securing clip 1 out slightly until it
engages in position.
• Unplug the handset 2 and plug in a new handset with the plug groove aligned with
the socket.
Make sure that the O-ring on the plug is not damaged. It seals the plug into the
control unit.
• Press the securing clip 1 in again.
• To complete the process, check that all the electrical bed adjustments function
properly, in accordance with chapter 4.4!
To Next Page
Loading...
