Instruction Manual for Lenus Care Bed
Page 23
Insert the other end of the bar into the lower
holding device at the foot end of the bed.
− The bar must be securely held in place by the
release button b .
− Make sure that the bar is properly engaged by
jiggling it up and down by hand.
−
Repeat steps 2 and 3 to attach the upper bar.
Repeat steps 2 and 3 to attach the third and fourth
bars, on the other side of the bed.
Attention! After they have been installed, the bars can fall and cause injuries
or damage to property if the release buttons [1] are jammed.
− Push and pull the bars to check that they have been locked in
place by the release buttons. It should not be possible to push
the bars up or down.
To Next Page
Loading...
