− Motorised adjustments are only possible if the bed is properly connected
to the mains supply.
− If the load is too high, an electronic overload switch is activated and the
control unit is automatically switched off. When the overload has been
removed, the drive system can be reactivated by pressing a button on
the handset.
− Continuous operation must not exceed two minutes! After this time, a
rest period of at least 18 minutes must be observed. (Alternatively: one
minute continuous operation followed by a nine minute rest period etc.)
− For safety reasons, if the maximum continuous operation time is
purposely disregarded, a thermal safety device will cut off the power
supply to prevent the drive system from overheating due to someone
continuously “playing” with the controls. After a short cooling off period,
the system can be reactivated.
− The adjustment range for all functions is electrically/mechanically limited
to the permitted ranges.
− As with every electrical device, even if all the specified limiting values
are observed during operation, disruptions from and to other closely
situated electrical devices cannot be ruled out (e.g. “crackling” in a
radio). In such cases, increase the distance between the devices. Switch
off devices temporarily if they are suffering from interference.
To Next Page
Loading...
