61
SURFACE PANEL LAYOUT
A Type R surface is made up using
a combination of 3 panel types:-
IM6413 a 6-wide Fader Panel,
MU6411 a Large Soft Panel and
MU6410 a Small Soft Panel. These
panels are put together in multiples
to form different surface sizes as
required.
IM6413 6-Wide Fader Panel
The panel shown top right consists of
6 x 100mm motorised faders, and each of
these faders has:-4 large user definable
buttons, a dedicated 96x96 pixel TFT
display for fader status information and at
the top of each fader are 2 user buttons, a
rotary control with integrated push switch
and another 96x96 pixel TFT display to
show a range of user definable controls
such as mic gain, trim etc.
Note that each fader can access two
layers described as Layer A and Layer B,
this can be switched from a user definable
button.
A Cat5e connector on the rear edge of
the panel provides both power and data
connections.
IM6413 TYPE R - 6 WIDE FADER PANEL TOP & REAR VIEWS
To Next Page
Loading...
