46 TYPE R Radio Production System Fixing Bracket Assembly Instructions
FADER & LSP ON DESK STAND (720-999003)
Fader and Large Soft panel on
desk stand, fixed 50 deg viewing
angle, see Fig 1. IM6413 & MU6410
Mounting options using 75mm
VESA mount fixing screw holes.
The Large Soft Panel is mounted
landscape.
Landscape, fixing hole positions,
see fig2
a) bottom edge 15mm to desk surface
without feet, with feet 20mm.
b) bottom edge 25mm to desk surface
without feet, with feet 30mm.
Assembly
Tools required (not supplied)
7mm adjustable/spanner/wrench open
ended.
PZ2 screw driver/ bit.
Stand is to be placed on desk surface.
Remove backing off (Item 3) adhesive feet
& stick on corners of riser base (Item 2).
Align 2 holes on Desk Riser (item 2) with
2 holes on underside of top edge of fader
panel and attach using 2 Screws (item 6)
with washers (item 5 &7), with plain
washer towards bracket as shown in Fig 4.
Loosely attach LSP bracket (Item 1) to
LSP with 4 screws (Item 6) and washers
(item 5 &6).
Align with fixing holes as shown in Fig
2, with plain washer towards bracket as
shown in Fig 4.
Align Bracket (item 1) with Riser (item 2)
and secure with 3 x M4 nuts (Item 4) and
washers (Item 5).
As shown in Fig 4. and tighten nuts.
Check Alignment of LSP with Fader panel
and tighten fixing screws to LSP
Do not over tighten. Typically 1Nm.
Place assembly on desk as required.
FIG 1 FADER & LARGE SOFT PANEL ASSEMBLY
FIG 2 FADER & LARGE SOFT PANEL ON DESK STAND LANDSCAPE MODE
Front
FIG 3 SUPPLIED PARTS TABLE
FIG 4 SUPPLIED PARTS ASSEMBLY
Item Number Part Number Description Quantity
1 720-985 LSP Interface Bracket 1
2 720-986 LSP on Desk riser 1
3 390-193 RBS-1BK Adhesive Foot 2
4
360-124 Nut M4 Nyloc 3
5 370-007 Washer M4 Plain 9
6 350-043 M4x10mm Pozi Pan 6
7
370-008 Washer M4 Internal lock 6
To Next Page
Loading...
