Chapter 4
4-51
4.4 Applying the Grease
4.4.1 Applying the Grease
0023-2642
iPF650 / iPF655
Apply the grease at the location shown below.
Smear the grease lightly and evenly with a flat brush.
Don't apply the grease to locations other than those designated. Unwanted grease may cause poor print quality, take particular care that grease does not get onto the
wiper, cap, or the linear scale.
T-4-2
1. Joint Base Rib [1]
F-4-108
No. Place Kind Quantity Note
1 Joint Base Rib Molykote PG-641 approx.8-20mg
2 Shaft Cleaner EU-1 soaks enough
3 Upper Cover Hinge Catch EU-1 approx.8-20mg
Roll Cover Slide Guid EU-1 approx.8-20mg
4 Contact between Pinch Roller Release Shaft and Pinch
Roller
Molykote PG-641 approx.8-20mg
Pinch Roller Pressure Release Gear Molykote PG-641 approx.8-20mg
Release lever Molykote PG-641 approx.8-20mg
Bushing of Feed Roller Molykote PG-641 approx.8-20mg
[1]
To Next Page
Loading...
