Chapter 8
8-1
8.1 Outline
8.1.1 Outline
0023-3204
iPF650 / iPF655
The printer indicates errors using the display and LEDs.
If an error occurs during printing, the printer status is also displayed on the status monitor of the printer driver.
The following three types of errors are displayed on the display:
- Warning
Status where the print operation can be continued without remedying the cause of the problem. This can, however, adversely affect the printing results.
- Error
Status where the print operation is stopped, and the regular operation cannot be recovered until the cause of the problem is remedied.
- Service call error
When a service call error occurs, the error is not cleared and the error indication remains on the operation panel even if the printer is powered off and on again.
(Occurrence of the service call error is indicated again at power-on.)
This measure is taken to prevent user's recovery of the service call error and damages to the printer.
Service call errors can be cleared, however, by starting up the printer in the service mode.
For how to take actions against warnings and errors, refer to "Troubleshooting".
Overview of warnings and error codes
The codes of warnings and errors are shown below acording to the system.
T-8-1
* "x" stands for a numeric or letter.
Code Diagnosis
0181xxxx-xxxx Ink warning
0180xxxx-xxxx Printhead warning
0184xxxx-xxxx Maintenance cartridge warning
0134xxxx-xxxx GARO warning
0303xxxx-xxxx Cover error
0301xxxx-xxxx
0306xxxx-xxxx
0386xxxx-xxxx
Media error
0313xxxx-xxxx Sensors, fans, motors error
0380xxxx-xxxx Printhead error
0381xxxx-xxxx
0383xxxx-xxxx
Ink error
0384xxxx-xxxx Maintenance cartridge error
0387xxxx-xxxx Cutter unit error
0389xxxx-xxxx Media take-up unit error
0390xxxx-xxxx Firmware error
Exxx-xxxx Service call error