Canon ImagePROGRAF iPF650 Series - Page 43

Chapter 1
1-29
T-1-11
*1: Available only if ManageRemainRoll is On.
*2: Available only if Width Detection is set to Off.
*3: Print Anyway is displayed when a job being held is selected.
*4: Available after Auto(Advanced) in Head Posi. Adj. has been used once.
*5: Available when you have specified Feed Priority > Adj. Priority > Automatic or Print Quality.
*6: Available when you have specified Feed Priority > Adj. Priority > Automatic or Print Length.
*7: Available only if Use Nesting is set to On.
*8: Not shown if you have set IPv4 Mode to Manual.
*9: Not shown if you have set NetWare to Off.
*10: Not shown if you have set Auto Detect to On.
*11: Follows the setting in Date Format.
*12: Viewing and configuration is possible for administrators, and only viewing for other users.
*13: Viewing and configuration is possible for administrators only.
*14: Displayed only on models equipped with HDD.
First Level Second Level Third Level Fourth Level Fifth Level
[System Setup] [Nozzle Check] [Frequency] [Standard]*
[1 page]
[Warning] [Off]*
[On]
[Use RemoteUI]*12 [On]*
[Off]
[Reset PaprSetngs]*12
[Erase HDD Data]*14 [High Speed]*12
[Secure High Spd.]*12
[Secure]*12
[Output Method]*14 [Print]*
[Print (Auto Del)]
[Save: Box XX]
[Print After Recv]*14 [Off]*
[On]
[Save: Shared Box]*12*14 [Off]
[On]
[Prep.MovePrinter]
[Admin. Menu]*12 [Change Password]*13
[Init.Admin.Pswd]*13
[Printer Info] [Paper Info]
[Ink Info]
[Head Info]
[System Info]
[Error Log]
[Other Counter]