1- 24
îš‹ Function Menus
TOP
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Index
Contents
Chapter 2
Using a Variety of
Media
Chapter 1
Basic Procedures
Color Adj.
Return Defaults Off*, On This restores all color settings at once to 2,
the factory default setting.
Color Adj. PM 1, 2*, 3 You can adjust the density of PM 1, 2*, 3 Y,
M, C, K, PM, PC one by one and perform the
corrections.
The settings can be performed in the range 1
to 3 (the standard factory default setting is
2). Set to 1 for a light adjustment or set to 3
for a dark adjustment.
Color Adj. PC 1, 2*, 3
Color Adj. Y 1, 2*, 3
Color Adj. M 1, 2*, 3
Color Adj. C 1, 2*, 3
Color Adj. K
1, 2*, 3
Interface Setup
EOP Timer 10 sec., 30 sec., 1 min., 2 min.,
5 min., 10 min.*, 30 min., 60 min.
Sets the job timeout setting for the printer.
TCP/IP Sets the TCP/IP protocol for the network
interface. After setting each TCP/IP item,
select Store Setting to save the settings and
enable them. This menu is displayed only
when the network interface is installed.
(→ P.5-12)
TCP/IP On The setting for TCP/IP protocol is locked On.
This setting cannot be changed.
IP Mode Manual*, Automatic This setting determines whether the IP
address is set automatically or entered
manually.
Protocol Sets the type of server when the printer is
set for automatic entry of the IP address.
DHCP
BOOTP
RARP
Off*, On
IP Setting Sets the printer network information if a fixed
IP address has been set.
IP Address
Subnet Mask
Default G/W
0.0.0.0* ~ 255.255.255.255 Allows entry of the IP address assigned to
the printer, network subnet mask, and
default gateway.
Menu Item Setting Values Function
To Next Page
Loading...
Need help?
General