1- 25
Function Menus
TOP
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Index
Contents
Chapter 2
Using a Variety of
Media
Chapter 1
Basic Procedures
NetWare Sets the network interface for NetWare
protocol. After setting each TCP/IP item,
select Store Setting to save the settings and
enable them. This menu is displayed only
when the network interface is installed.
(→ P.5-35)
NetWare
Off*, On Determines whether NetWare protocol is
used.
Frame Type Auto Detect, Ethernet 2, Ethernet
802.2*, Ethernet 802.3, Ethernet
SNAP
Selects the frame type to use.
Print Service Bindary Pserver, RPrinter, NDS
Pserver*, NPrinter
Selects the print service.
AppleTalk On, Off*,
Determines whether AppleTalk protocol is
used. After setting each TCP/IP item, select
Store Setting
to save the settings and enable
them. This menu is displayed only when the
network interface is installed. (
→ P.5-30
)
Ethernet Driver Sets the method of communication for the
network interface board. After setting each
TCP/IP item, select Store Setting to save
the settings and enable them. This menu is
displayed only when the network interface is
installed. (→ P.5 - 6 )
Auto Detect On*, Off Automatically recognizes the LAN
communication protocol. If set to Off, the
communication method or Ethernet type are
enabled.
Comm. Mode Half Duplex*, Full Duplex Selects the LAN communication method.
Ethernet Type 10 Base-T*, 100 Base-TX Selects the LAN communication speed.
Spanning Tree Not Use*, Use This selection determines whether the LAN
spanning tree signal is received.
MAC Address Displays the MAC address of the network
interface board.
Menu Item Setting Values Function
To Next Page
Loading...
