6- 6
îš‹ Responding to Error Messages
TOP
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Index
Contents
Chapter 2
Using a Variety of
Media
Chapter 1
Basic Procedures
Load Cut Sheet
Problem1: The printer is waiting for a cut sheet to be
loaded.
Solution1: Follow the procedure below to set the media
type and media size settings the same as those
for the cut sheet. (→ P.2-35)
1. Load a cut sheet that is the same type and
size as the printer settings.
2. Select the media type.
3. Press the OK button.
Solution2: Hold down the Stop/Eject button for at least 1
second to stop printing.
Remove Cut Sheet
Problem1: The printer waits for you to remove the ejected
sheet.
Solution1: Perform the procedure below to remove the cut
sheet. (→ P. 2- 3 9)
1. Open the upper cover.
2. Push the release lever to the rear and
remove the cut sheet.
3. Pull the release lever to close it.
4. Raise the upper cover stopper to release the
lock then close the upper cover.
To Next Page
Loading...
Need help?
General