8400-M022-O1 Rev K Model 190 Indicator
Setup
Enter SETUP and proceed to the Options Setup.
option
With option displayed, press the TARE key. The display will change to show opt=.
Proceed to the opt= parameter.
opt?
With opt? displayed, press the TARE key. The display will change to no. Press the
Fn/ key to toggle to yes and press the TARE key. The display will change to opt=.
Proceed to the opt= parameter.
Otherwise, to skip the Options Setup, press the TARE key to advance to the fUnC?.
prompt.
oPt= (Option)
Press the TARE key to show the current setting. If the setting displayed is acceptable,
press the TARE key again to save it.
Otherwise, use the Fn/▲ key to toggle to a new setting and press the TARE key to save
it. Allowable values are:
0 = No Option Card Installed
1 = Serial Interface, Ethernet, Wi-Fi, or USB Option Card Installed
4 = Digital to Analog Converter Option Card Installed
bAUd= (Option Card Baud Rate)
Press the TARE key to show the current setting. If the setting displayed is 96, press the
TARE key again to save it.
Otherwise, use the Fn/ key to toggle the baud rate setting to 96 (9600 Baud) and press
the TARE key to save it.
NOTE: The default baud rate is 9600 and must match the baud rate in the XPORT Channel
1 Serial Setting.
Prty= (Option Card Parity Setting)
Press the TARE key to show the current setting. If the setting displayed is 0, press the
TARE key again to save it.
Otherwise, use the Fn/ key to toggle the parity setting to 0 (No Parity with 8 data bits) and
press the TARE key to save it.
NOTE: The default parity is 0 (No Parity with 8 data bits) and should not be changed.
To Next Page
Loading...
