Cardinal 190 - KEYPAD; Standard Key Functions

8400-M022-O1 Rev K  Model 190 Indicator
41
Key Lockout Feature
The Key Lockout Feature allows keys on the indicator to be disabled for use by the operator
“during normal operation”. During normal operation, when the operator presses a locked key,
the display will show LoCd for about a 1/2 second and the key will be ignored.
NOTE: The Key Lockout Feature only disables keys for use during normal
operation, not setup and calibration.
LoCoUt
With LoCoUt displayed, press the TARE  key. The display will change to show 2ero=.
Proceed to the 2ero= parameter.
LCoUt?
With LoCoUt? displayed, press the TARE  key. The display will change to no. Press the
Fn/ key to toggle to yes and press the TARE  key. The display will change to 2ero=.
Proceed to the 2ero= parameter.
Otherwise, to skip the Key Lockout Feature setup, press the TARE  key to advance to the
opt?. prompt.
2Ero= (ZERO Key)
Press the TARE  key to show the current setting. If the setting displayed is acceptable,
press the TARE  key again to save it.
Otherwise, use the Fn/ key to toggle the setting and press the TARE  key to save it.
UnLoCd
LoCD
Key is Unlocked (Enabled)
Key is Locked (Disabled)
tAre= (TARE  key)
Press the TARE  key to show the current setting. If the setting displayed is acceptable,
press the TARE  key again to save it.
Otherwise, use the Fn/ key to toggle the setting and press the TARE  key to save it.
UnLoCd
LoCD
Key is Unlocked (Enabled)
Key is Locked (Disabled)
net= (NET/GROSS Key)
Press the TARE  key to show the current setting. If the setting displayed is acceptable,
press the TARE  key again to save it.
Otherwise, use the Fn/ key to toggle the setting and press the TARE  key to save it.
UnLoCd
LoCD
Key is Unlocked (Enabled)
Key is Locked (Disabled)