8400-M022-O1 Rev K Model 190 Indicator
Fn/ Key Combination Features
The Fn/ key is also used in combination with the other keys on the keypad to access
additional indicator features. Those features and their associated key combinations are as
follows:
Fn/, ZERO KEY
This combination will enter the Review mode of Setup and Calibration. Refer to the Setup
Review section of this manual for details.
Fn/, TARE KEY
This combination will display the Tare weight. If a tare weight has not been stored, then the
notArE error message will be displayed.
Fn/, NET/GROSS KEY
This combination will allow viewing of the Audit Trail Counters. Refer to the View Event
Counters section of this manual for details.
Fn/, UNITS/ KEY
This combination will enter the Test Mode/Diagnostics Feature. This feature is used to
conduct a test of all display elements and perform self-diagnostics. Refer to the
Test/Mode/Diagnostics section of this manual for details.
Fn/, PRINT KEY
This key combination is used for several functions. Print formats are selected by using the
Fn/ key and PRINT keys in combination. Note that when the PRINT key is pressed the
indicator looks for the selected format. If no visual ticket is found it reverts to the print tab
settings. Refer to the Operation, Ticket Format Selection for details.
This key combination is also used to enter the Preset Weight Comparators “PWC” weight
values. Refer to the Operation, Preset Weight Comparators section for details.
To Next Page
Loading...
