8400-M022-O1 Rev K Model 190 Indicator
P3 I/O Interconnection Diagram
Re-Installing the Front Panel
1. After all terminations have been made, remove the excess cable from the indicator
enclosure and securely tighten each of the cable gland connectors.
2. Use a wrench to ensure the gland connectors are tight (to maintain a water-tight seal) but do
not over-tighten them.
3. Make certain no cables or wires are exposed between the rear housing and front housing
assembly and then place the front housing assembly onto the rear housing.
4. Secure by tightening the 4 Captive screws loosened earlier.
To Next Page
Loading...
