8400-M022-O1 Rev K Model 190 Indicator
Options Setup
option
With opt displayed, press the TARE key. The display will change to show opt=.
Proceed to the opt= parameter.
opt?
With opt? displayed, press the TARE key. The display will change to no. Press the
Fn/ key to toggle to yes and press the TARE key. The display will change to opt=.
Proceed to the opt= parameter.
Otherwise, to skip the Options Setup, press the TARE key to advance to the
fUnC?. prompt.
opt= (Option)
Press the TARE key to show the current setting. If the setting displayed is acceptable,
press the TARE key again to save it.
Otherwise, use the Fn/ key to toggle to a new setting and press the TARE key to save
it. Allowable values are:
0 = No Option Card Installed
1 = Serial Interface, Ethernet, Wi-Fi, or USB Option Card Installed
(See Appendix C, D, E and G for details)
4 = Digital to Analog Converter Option Card Installed
(See Appendix F for details)
IMPORTANT! The settings for the following prompts, baUd=, Prty=, and
Cont2= are only applied when the opt= parameter is set to 0 or 1.
bAUd= (Optional Serial Interface Baud Rate)
Press the TARE key to show the current setting. If the setting displayed is acceptable,
press the TARE key again to save it.
Otherwise, use the Fn/ key to toggle to a new baud rate setting for the serial ports and
press the TARE key to save it. Allowable settings are:
To Next Page
Loading...
