8400-M022-O1 Rev K Model 190 Indicator
Print Tab Settings
Print
With Print displayed, press the TARE key. The display will change to port=. Proceed
to the port= parameter.
Print?
With Print? displayed, press the TARE key. The display will change to no. Press the
Fn/ key to toggle to yes and press the TARE key. The display will change to port=.
Proceed to the port= parameter.
Otherwise, to skip the Print Tab Settings setup, press the TARE key to advance to the
fspan? prompt.
The general format for the input is A = YY.XX where A is the
character identifying the data printed, YY is the number of lines
down and XX is the number of columns to the right.
NOTE: Enter 00 in either the YY or XX location to
disable the data from printing.
Port= (Select Serial Interface for Printing)
Press the TARE key to show the current setting. If the setting displayed is acceptable,
press the TARE key again to save it.
Otherwise, use the Fn/ key to toggle to a new setting and press the TARE key to save
it. Allowable values are:
0 = Ticket Printing Disabled
1 = Standard Serial Interface used for Printing
2 = Optional Serial Interface used for Printing
(Serial Option Card must be installed)
HoUr= (Time Print Location)
Press the TARE key to show the current setting for the Time Print Location. If the setting
displayed is acceptable, press the TARE key again to save it.
Otherwise, use the Fn/ and UNITS/ keys to enter a new location and press the
TARE key to save it.
dAtE= (Date Print Location)
Press the TARE key to show the current setting for the Date Print Location. If the setting
displayed is acceptable, press the TARE key again to save it.
Otherwise, use the Fn/ and UNITS/ keys to enter a new location and press the
TARE key to save it.
To Next Page
Loading...
