Cardinal 190 - 190-USB Operation

8400-M022-O1 Rev K  Model 190 Indicator
124
Cont2= (Continuous Output on Option Card)
Press the TARE  key to show the current setting. If the setting displayed is acceptable,
press the TARE  key again to save it.
Otherwise, use the Fn/ key to toggle to a new setting and press the TARE  key to
save it.
YES
= Continuous Output on Optional Serial Interface
no
= No Continuous Output on Optional Serial Interface
IMPORTANT! The setting for the type= is only applied when the opt=
parameter is set to 1 and the Cont2= parameter is set to YES.
tyPE= (Continuous Output Format)
Press the TARE  key to show the current setting. If the setting displayed is acceptable,
press the TARE  key again to save it.
Otherwise, use the Fn/ key to toggle to a new setting and press the TARE  key to save
it. Allowable settings are:
0 = Continuous Output uses SMA format
1 = Continuous Output uses Cardinal Scoreboard format
2 = Continuous Output uses Cardinal SB500 with traffic control format
NOTE: Continuous Output tYPE= settings are for the selection of the format
only. A scoreboard cannot be connected directly to the 190-USB.
NOTE: Refer to the CONT1= Continuous Output on Serial Interface, tYPE= parameter
section for a description of output formats 0 and 1.
190-USB Operation
A connection to the 190-USB option card can be used to send commands to the 190. A
description of the available commands is described in the ASCII Commands section.
NOTE: When the 190 indicator is turned OFF, power is removed from the USB
transceiver. The serial communication software connecting the computer to
the 190-USB must be disconnected before the 190 indicator is turned OFF. If
the communication software does not release the connection to the USB
Comm port before power to the 190 indicator is turned off, the USB Comm
connection will not restore the connection when the 190 indicator is powered
ON again. To restore the connection, the USB cable must be unplugged and
reconnected.