8400-M022-O1 Rev K Model 190 Indicator
dACtSt
Press the TARE key and the Fn/▲ key to switch to the YES prompt.
Press the TARE key to enter the DAC output test function, pressing the TARE key with
the no prompt will skip the output test.
The dAC Lo prompt is displayed and the output of the DAC is the Low value for the range
selected.
Press the Fn/▲ key to switch to the High value of the range on the DAC output, dAC Hi
will be displayed.
Continue pressing the Fn/▲ key to toggle between the Low and High output.
When done testing the DAC output press the TARE key.
9dAC=
This sets the DAC output to follow the Gross weight only or the displayed weight (gross or
net).
Press the TARE key to show the current value. If the setting displayed is acceptable,
press the TARE key again to save it and advance to the fUnC? prompt.
Otherwise, press the Fn/▲ key to toggle between YES and no and press the TARE key
and advance to the fUnC? prompt.
9dAC=YES 9dAC=no
DAC output is Gross Weight Only
DAC output is the displayed Weight (gross or net)
DAC Wiring
DAC Option Card P1 Power Connection
To power the DAC option card, connect P1 on the DAC (Pin +9V and GND) to connector P2
of 190 Main Board (Pin +9V and GND).
DAC Option Card P3 Analog Out Connections
To Next Page
Loading...
