8400-M022-O1 Rev K Model 190 Indicator
Lo=
This is the value, in weight, which outputs zero volts (or 0 or 4 ma) from the DAC.
All weight below this target will output zero volts (or 0 or 4 ma).
Press the TARE key to show stored value. If the setting is acceptable, press the
TARE key again to save it.
Otherwise, using the numeric keys enter the desired weight value, and press the TARE
key to save it. Allowable values are -99999 to 999999.
NOTE: The NET/GROSS key is used to change the weight sign. For example, to input -
1000 as the weight value, press 1000 NET.
Hi=
This is the value, in weight, which outputs the maximum selected voltage and current (see
oUt=). All weights above this value will output maximum volts from the DAC.
Press the TARE key to show the stored value. If the setting is acceptable, press the
TARE key again to save it.
Otherwise, using the numeric keys enter the desired weight value, and press the TARE
key to save it. Allowable values are 1 to 999999.
NOTE: This weight must be a positive value, up to the capacity of the scale, and above the
Hi= value.
oUt=
This is the maximum output value in volts (00.01 to 10.00). All weight values equal to or
greater than Hi= will output this value.
NOTE: If the scale goes oCAP (over capacity), this value is used.
Press the TARE key to show the stored value. If the setting is acceptable, press the
TARE key again to save it.
Otherwise, using the numeric keys enter the desired output value, and press the
TARE key to save it. Allowable values are 00.01 to 10.00.
NOTE: If one of the current output ranges is selected, set oUt= to:
10 X (max_current – 4) / 16
To Next Page
Loading...
