Cardinal 190 - Checkweigher

8400-M022-O1 Rev K  Model 190 Indicator
57
INDICATOR SETUP REVIEW
The 190 indicator allows several operational parameters to be reviewed and changed without
breaking the calibration seal.
Accessing Setup Review
1. With the indicator ON, press the Fn/ key and then the ZERO key.
2. The display will change to show td= (the prompt for selection of a 12 or 24-hour clock).
3. Press the TARE  key to show the current setting. If the setting displayed is acceptable,
press the TARE  key again to save it. Otherwise, use the Fn/ key to toggle to a new
setting and press the TARE  key to save it and advance to the next prompt.
4. To exit Setup Review, press the TARE  key to step through the remaining prompts OR
at any time, cycle the power (press the ON/OFF key twice).
Td=
Time and Date
(Select 12 or 24-hour clock)
d in=
Digital Input
(Disable or Select key function)
d out=
Digital Output
(Disable or Select Preset/Checkweigher function)
SLEEP=
Sleep Mode
(Disable or Select number of minutes before entering sleep mode)
A off=
Auto Shutoff
(Disable or Select number of minutes before automatic shutoff)
toUCH=
Key Touch Sensitivity
(Select number of milliseconds key must be touched before the key press
is acted upon)
Sio?
Serial Input/Output Configuration
(Select YES or NO)
baUd=
Select Serial Port Baud Rate
prty=
Select Serial Port Parity
Cont1=
Enable or Disable Continuous Output to the Serial Port
type=
If
Cont1=YES
(Select Continuous Output Format, SMA or Cardinal Scoreboard)